What is an amine gas treating unit?
An amine gas treating unit removes hydrogen sulfide and carbon dioxide from gas streams by absorbing them into a water-based amine solution. The loaded (rich) amine is heated in a regenerator, which strips off the acid gas, and the cleaned (lean) amine returns to the absorber. Gas processing plants, refineries and liquefied natural gas (LNG) plants use these units.
By Jun Zhong, Editor·Researched and drafted by Beacon's AI newsroom·Checked by Jun Zhong, Editor·Last checked ·Next review
What does an amine unit remove, and why?
US federal rules define acid gas as hydrogen sulfide (H2S), carbon dioxide (CO2) or both, separated from sour natural gas in an acid gas removal unit that uses liquid or solid absorbents or membranes 3. An amine unit is the liquid-absorbent type. The US Environmental Protection Agency (EPA) classes gas as sour when H2S exceeds 0.25 grains per 100 standard cubic feet, or 5.7 mg per normal cubic meter; using AP-42's own conversion factors, that is about 4 parts per million by volume (ppmv) 1.
Each end user sets its own limit. Pipeline-quality gas may carry only traces of H2S and CO2, according to the US Energy Information Administration (EIA) 8. Gas entering LNG liquefaction is commonly cleaned to below 50 ppmv CO2 9. In refineries, amine units remove H2S and CO2 from sour gas and liquid hydrocarbon streams, according to the Occupational Safety and Health Administration (OSHA) 4.
Amine processes accounted for over 95% of US gas sweetening, with carbonate processes, solid beds and physical solvents making up the rest 1. EPA's greenhouse gas inventory for 1990 to 2005 counted 287 acid gas removal units in the US natural gas industry 2.
How does an amine unit work, step by step?
The unit is a closed loop: amine picks up acid gas in one tower and releases it under heat in another 2.
| Step | Equipment | What happens |
|---|---|---|
| 1. Absorption | Absorber (also called contactor) | Sour gas meets lean amine; the amine takes up H2S and CO2, and treated (sweet) gas leaves the vessel |
| 2. Flash | Flash tank | Pressure on the rich amine drops, releasing dissolved hydrocarbons; this flash gas goes to fuel or is recycled |
| 3. Filtration | Mechanical and activated carbon filters | Solids, impurities and dissolved hydrocarbons are removed from the circulating amine |
| 4. Heat exchange | Lean/rich exchanger | Hot lean amine from the regenerator bottom preheats the rich amine on its way in |
| 5. Regeneration | Regenerator (stripper) with reboiler | Heat from steam or a heating medium makes vapor that rises through the tower and strips H2S and CO2 from the rich amine |
| 6. Overhead | Condenser, reflux drum and reflux pump | Acid gas leaves the top; condensed liquid returns to the tower as reflux |
| 7. Return | Booster pump and filter | Lean amine is pumped back to the absorber |
Sources: EPA Natural Gas STAR, 2007 2; Leal Navarro et al., 2018 6; OSHA memorandum, 1986 5.
Which amines are used, and what degrades them?
The amines most often named for this service are monoethanolamine (MEA), diethanolamine (DEA) and methyldiethanolamine (MDEA) 4. EPA describes the solutions as based on mono-, di- or tri-ethanol amines 1. For deep CO2 removal ahead of LNG liquefaction, Mokhatab et al. name promoted MDEA as the preferred chemical solvent 9.
The solution does not stay clean. Heat stable salts form when the amine reacts with acids other than H2S and CO2, and both these salts and amine degradation products raise corrosion rates; high temperature also degrades amine, and the plant studied in that 2011 paper kept its regenerator bottoms below 132 °C (270 °F) for this reason 7. OSHA adds that air has to be excluded, because oxygen oxidizes the amine 4.
What happens to the acid gas the unit removes?
The H2S-rich gas from the regenerator overhead can be turned into elemental sulfur or sulfuric acid; otherwise it is incinerated, flared or vented, and incineration converts the H2S to sulfur dioxide 1. In a sulfur recovery unit, the Claus process converts H2S to sulfur through thermal and catalytic reactions 4.
CO2 streams are often vented; in the Permian Basin, much of the CO2 removed at gas plants was reinjected for enhanced oil recovery 8. Regeneration also releases some methane absorbed with the acid gas, which is why EPA's Natural Gas STAR program studied alternative solvents and flash gas recovery 2.
Where integrity problems show up
| Unit or equipment | Typical integrity issue | In the Library |
|---|---|---|
| Absorber shell and welds | Amine-related corrosion and cracking; OSHA (1986) cited survey data showing cracking in about 60% of 24 refinery amine absorbers, including 12 of 14 MEA units | What is amine corrosion and amine cracking? |
| Absorber plate steel in wet sour service | Hydrogen-induced cracking: the National Bureau of Standards found the plate steel of a failed absorber susceptible to it 5 | Hydrogen induced cracking |
| Field repair welds that were not stress relieved | Especially sensitive to amine-induced corrosion and cracking 5 | What is post-weld heat treatment (PWHT)? |
| Regenerator bottom and reboiler | Corrosion linked to high temperature, heat stable salts and amine degradation products; OSHA ties corrosion control to these temperatures | What is amine corrosion and amine cracking? |
| Regeneration equipment and amine piping | Cracking also reported in associated equipment: 16 instances in the survey data OSHA cited in 1986 | What is stress corrosion cracking (SCC)? |
Sources: OSHA memorandum of 11 April 1986 5; OSHA Technical Manual, Section IV, Chapter 2 4; Hajilary et al., 2011 7.
Common questions
- Is an amine unit the same as a glycol dehydrator?
- No, though both use an absorber and a heated regenerator. A glycol unit removes water from gas (EIA, 2006; 30 CFR 250.857), while an amine unit removes H2S and CO2. Both appear among the steps EIA (2006) describes for gas plants; see [What does a gas processing plant do?](/library/gas-processing-plant/).
- What is the difference between rich and lean amine?
- Rich amine leaves the absorber loaded with acid gas and some dissolved hydrocarbons. Lean amine has been stripped in the regenerator and is ready to absorb again (EPA, 2007).
- What happened in the 1984 amine absorber rupture?
- On 23 July 1984, an amine absorber at a refinery in Romeoville, Illinois, ruptured and released flammable gas, which ignited; 17 people died (OSHA, 1986). OSHA's field investigation found a long history of in-service defects in the vessel.
- Is amine treating the same as sulfur recovery?
- No. The amine unit separates H2S from the gas; a downstream sulfur recovery unit, such as a Claus unit, converts that H2S into sulfur (OSHA Technical Manual).
Beacon explains these concepts in its own words for education. It does not reproduce or replace the standards cited, and Winda is not affiliated with or endorsed by the organizations that publish them. Engineering decisions need the current edition of the standard and a qualified engineer.
Sources
- 1.AP-42, Compilation of Air Emission Factors, Section 5.3: Natural Gas Processing · U.S. Environmental Protection Agency
- 2.Acid Gas Removal Options for Minimizing Methane Emissions: Lessons Learned from Natural Gas STAR · U.S. Environmental Protection Agency, Natural Gas STAR Program ·
- 3.40 CFR 98.238, Definitions (Subpart W, Petroleum and Natural Gas Systems) · Electronic Code of Federal Regulations (eCFR)
- 4.OSHA Technical Manual, Section IV, Chapter 2: Petroleum Refining Process · Occupational Safety and Health Administration
- 5.Potentially Hazardous Amine Absorber Pressure Vessels Used in Refinery Processing (memorandum) · Occupational Safety and Health Administration ·
- 6.Computer-Aided Parametric Sensibility Analysis of an Amine Treatment Unit (Chemical Engineering Transactions 70, 1261 to 1266, doi:10.3303/CET1870211) · AIDIC (J.D. Leal Navarro, R.J. Mestre Escudero, A. Puerta Arana, Y. Peralta Ruiz, A.D. Gonzalez-Delgado)
- 7.Amine Gas Sweetening System Problems Arising from Amine Replacement and Solutions to Improve System Performance (Journal of Petroleum Science and Technology 1(1), 24 to 30) · Research Institute of Petroleum Industry (N. Hajilary, A. Ehsani Nejad, S. Sheikhaei, H. Foroughipour)
- 8.Natural Gas Processing: The Crucial Link Between Natural Gas Production and Its Transportation to Market · U.S. Energy Information Administration, Office of Oil and Gas
- 9.Gas pretreatment considerations for LNG plants feeding with pipeline-quality gas · Gas Processing & LNG (S. Mokhatab, S. Northrop, R. Palla, B. Sharma)
- 10.30 CFR Part 250, Subpart H, Oil and Gas Production Safety Systems · Electronic Code of Federal Regulations (eCFR)