Skip to content
Beaconby Winda
FactAsset Integrity Management · Fitness-for-service

Burst pressure

·4 sources

Short answer

Burst pressure is the internal pressure at which a pipe, vessel or other pressure-containing part ruptures because its wall can no longer hold the load.

By , Editor·Researched and drafted by ·Checked by , Editor·Last checked

US hazardous liquid pipeline rules make a corrosion anomaly an immediate repair condition when a remaining strength calculation shows a predicted burst pressure below the established maximum operating pressure (49 CFR 195.452) 2. Gas transmission rules call it predicted failure pressure and treat metal loss as an immediate repair condition when that value is at or below 1.1 times the maximum allowable operating pressure, calculated by a method 49 CFR 192.712 accepts (49 CFR 192.933) 3,4.

It is the pressure at which a pipe or vessel would split open; for corroded pipe it is estimated from the wall that is left. In the 2001 Humber refinery explosion in England, an elbow worn from about 7 to 8 mm to 0.3 mm burst 1.

See alsoRemaining strength factorHoop stress

Sources

  1. 1.Public Report of the Fire and Explosion at the ConocoPhillips Humber Refinery on 16 April 2001 (copy hosted by the Institution of Chemical Engineers) · UK Health and Safety Executive (HSE)
  2. 2.49 CFR 195.452, Pipeline integrity management in high consequence areas · eCFR, US Office of the Federal Register
  3. 3.49 CFR 192.933, What actions must be taken to address integrity issues? · eCFR, US Office of the Federal Register
  4. 4.49 CFR 192.712, Analysis of predicted failure pressure and critical strain level · eCFR, US Office of the Federal Register